Chief MTMP1U Manuale Scaricare il pdf (Pagina 10)

MTMP1U Installation Instructions

1. Hang screen onto the top rail of the mount (Z).(See Figure 10)

• Move latch on top of interface bracket to OPEN position

and hang top hook of interface brackets (X and Y) onto

the top rail of the mount (Z). (See Figure 10)

NOTE: The screen initially installs into the "service mode" to

allow easy cable access.

Figure 10

2. Adjust screen and rails to desired viewing position.

3. Route cables between wall and rails.

CAUTION: PINCH POINTS! Keep fingers, hands and

cables out of pinch point areas.

4. Pull downward on the pull cords and swing inward toward

wall, latching interface brackets to lower rail and fastening

bottom of screen to the mount. (See Figure 10)

5. Attach end of pull cord (a magnet) to mount so it does not

extend beyond bottom of screen. (See Figure 10)

Adjustments

Horizontal Adjustment

1. The wall mount may be adjusted side to side at the point(s)

of attachment. (See Figure 11)

Figure 11

2. The screen may be adjusted along rails side to side.

NOTE: NEVER place both interface brackets (X and Y) to one

side of the wall mount center line! (See Figure 9)

NOTE: Do NOT allow both interface brackets (X and Y) to be

located on same side of wall mount. (See Figure 9)

3. Move latch on top of interface brackets to CLOSED

position. (See Figure 13)

Roll/Height Adjustment of Wall Mount

NOTE: The height adjust of the wall mount allows adjustment

of +

1/2".

1. Turn to right (tighten) to raise side of screen. (See Figure 12)

2. Turn to left (loosen) to lower side of the screen.

Figure 12

Pull cord

Latch in

OPEN

position

3" horizontal

adjustment possible

Raises screen

Lowers screen

(Screen not shown for clarity)

(S)

1 2 ... 5 6 7 8 9 10 11 12

Commenti su questo manuale

Nessun commento

Chief MTMP1U Manuale Pagina 10

Commenti su questo manuale

Prodotti e manuali riguardandi Staffa a muro con snodo Chief MTMP1U